The cabinet is supplied as standard with heavy duty stainless steel latches and there is provision for secondary security locks.

The doors feature a unique anti-poster device. The rugged corrugations break up the flat surface of the door helping prevent posters adhering. They also offer increased rigidity.

Roof
Double skin pitched roof bolted to body. Alternate roof styles can be provided on request including flat, high pitched or steep slope versions to dissuade climbing or sitting on cabinet. The bolted construction enables the roof style to be changed retrospectively where conditions dictate.

Body
Fully welded one piece construction in 2mm thick material. In the event of severe accisdent damage, the body can be changed without disconnecting the cross-connection equipment.

Base
2mm chrome steel base. Seprated from body by full flange rubber gasket to prevent galvanic corrosion.

Doors
Double doors with heavy duty hinges. Opening to 110 degrees doors can be lifted off for additional access. Door stay retain the doors at 90 degrees. Replaceable synthetic rubber car boot type seals are used throughout.

Latches
Stainless steel half-turn compression latch to provide excellent seal. Additional customised styles are available. O type ring seals withing the latch body ensure lifetime lubrication and IP65 performance. Latches are tested to withstand a test requirement of 50NM. Provision is made for a secondary security lock to be fitted on assembly or retrospectively by the end user with removable blanking covers fitted to standard profile cutouts. Fitment by end user ensures controlled access.

Earthing
Safety earth provided by two bolts mounted at bottom of cabinet. Insulated secondary / signal earth mounted on plinth - may be user repositioned. Support provided for jumper cables.

Equipment mounting (Backboard)
Cabinets are supplied as standard with fixings to allow installation of Krone, MS2 or strips cross connection. Alternatively the cabinets can be supplied with stainless steel, aluminum, marine ply or chipboard backboards. Star punched or custom punched units are available in all three of the metal versions.

Ventilation
Cabinets can operate in sealed or ventilated mode. In ventilated mode, convection currents draw fresh air in through louvres at sides of cabinet forcing warm air out through concealed vents above the doors. Side vents are protected by insect-proof mesh. Changing between sealed and ventilated modes can be done easily without additional components. The cabinet roof has a double skin and air gap to help protect against solar gain. This "double glazing" also helps to reduce condensation.

Finish
Pre-treatment by chemical etching followed by powder coating with polyester material in customers choice of colour (standard is green). Alternate colour finishes and silk screened or embossed logos are available on request. The gloss finish enables graffitti to be removed using mild solvents or mild abrasive compounds. Damage can be touched up using brush or aerosol techniques. Repainting is best achieved using two pack poly-urethane compounds although gloss paint can be used.

Dimensions

Dimension	Value
Height (total)	1195mm
Width	1300mm
Depth	280mm
Door opening (width)	1219mm
Door opening (height)	845mm

Copyright © 2002 Austin Taylor Communications